APPLICATIONS / POWER GENERATION

Composite piping for power generation and cooling circuits

For pumped circuits, assess pressure peaks and possible vacuum as well as operating pressure. PN alone does not replace a hydraulic assessment.

01 / APPROACH

First the circuit. Then the material.

A steel piping layout cannot be reused for GRP without assessment. Support spacing, thermal expansion and valve loads must be checked.

HYDRAULICS / WHY PN IS NOT ENOUGH

Operating pressure is not the same as a pressure peak.

Long pumped lines and large diameters require pressure-surge assessment. Wall flexibility affects wave speed but does not replace hydraulic analysis.

01

Steady operation

The conditions shown on the drawing and enquiry are not enough to design a pumped system.

02

Positive pressure wave

Rapid valve closure or pump failure can cause a pressure surge. Both pressures and resulting forces are checked in the design.

03

Possible vacuum

Some transient conditions can create vacuum. Resistance must be verified in the design of the specific system.

02 / WHAT TO ASSESS

Three things we need from you.

01

Fluid and parameters

Water composition, temperature, operating and surge pressures, and vacuum during draining.

02

Routing and connections

Supports, anchors, expansion and force transfer at elbows and branches. Restraint must follow the system design.

03

Hydraulic assessment

The need for surge analysis depends on the system parameters. Its results verify loading against the limits of the selected system.

Have hydraulic data or a surge analysis? We will review it against GRP/GRE limits.

Start with the fluid, temperature and location. We will clarify the remaining details together.

CONTACT ZEFYR ↗